top of page
Ku Band Multi-grade
U1X1-1 Single with Single 0°~6° LNB
The special dual Ku-Band LNB unit consisting of two Single LNBs is designed to receive close-spaced satellites, and it is the simplest solution to achieve one dish receiving two satellite signal simultaneously. In addition you can adjust the LNB each other. (adjustable distance range: 0~37 mm) For example, in area of Europe, Hot Bird 13 E and Astra 19.2 E satellites are popular, and they enable reception by monoblock LNB and single dish without requiring an expensive and noisy rotator. A similar advantage is provided by the special dual Ku-Band LNB unit to receive the two satellite signal simultaneously. Moreover, it is adjustable to receive two satellites of other angle space.
Step 1: Set the dish antenna on suitable location, Make sure there are no obstacles that may prevent the dish from receiving signal.
Step 2: Fixup right LNB of the special dual LNB unit with LNB holder as shown on the figure, run cables between the LNB(s) and the receiver(s).
Step 3: Set your dish to the proper Azimuth and Elevation settings to receive satellite A signal(left one). (This information should be supplied with your dish)
Step 4: Adjust the dish and LNB which fixed in the LNBF holder to get the highest satellite signal.
Step 5: Fixup the dish (Azimuth and Elevation).
Step 6: Slide out left one LNB and rotate slowly to receive satellite B signal (right one), adjust the sliding length and rotate angle to get the highest satellite signal.
Step 7: Use the attached Screw to fix the left LNB.
Step 8: Re-confirm both LNBs getting the maximum signal.
Step 9: Turn on the receiver and television and enjoy your favorite program.
Note: You can use a DiSEqC switch to switch between two satellites.
• External DiSEqC Switch Supported to support two Satellites
• Easy Installation, Easy to Adjust
• Economical LNB, One Dish antenna suitable for 2 Satellites
• Multi Satellite Reception using one single universal dish antenna
• Water Proof, Weather Protection, High Performance LNB
• High Gain, Ultra Low Noise Figure, DVB-S2 (HDTV) Compliant
• Qualiﬁed & 100% Quality Controlled
F Connector Options
• Input Frequency Range
Low Band: 10.70~11.70GHz
High Band: 11.70~12.75GHz
• Output Frequency Range
Low Band: 950~1950MHz
High Band: 1100~2150MHz
• Noise Figure
Low Band: 0.6dB(Typ.)
High Band: 0.6dB(Typ.)
• Conversion Gain
• Gain Flatness
• Cross POL. Isolation
• L.O. Frequency
• L.O. Frequency Stability
• Operating Temperature
• L.O. Phase Noise
• Image Rejection
• Output VSWR
• Output Power
(at 1dB gain compression)
• Connector Type
75Ω Female Connector
• DC Current Consumption
• Low/High Band Switching
• POL. Switching Voltage
• Adjustable Distance Range
bottom of page